Space Mounting Carbon Dioxide Sensor with 0/10Vdc Output

The self-calibrating microprocessor-controlled space air quality sensor is used to determine air quality based on a mixed gas sensor/VOC sensor.

It is used to measure air quality and to quantify room air pollution caused by contaminating gases.

The air quality sensor does not trace concentrations of individual gases, but assesses the mixed gas concentration.

Detectable gases: mixed gas, vapours of VOCs, cigarette smoke, automobile exhaust gases, human exhalation, combustion smoke (from wood, paper, plastics).

The sensor‘s lifetime depends on the type of burden and gas concentration.

Power Supply:                            24V AC / DC (± 10%)
Power Consumption:             < 1.5W / 24V DC typical < 2.9VA / 24V AC typical Peak Current 200mA
Sensor:                                             VOC sensor (metal oxide), with automatic self-calibration (VOC = volatile organic compounds)
Measuring Range:                       0…100% air quality; referred to calibrating gas; multi-range switching (selectable via DIP switches), VOC sensibilit:y low, medium, high
Output:                                               0 – 10V (OV = clean air, 10V = contaminated air) or 4…20mA (selectable via DIP switches; switch point adjustable from 0…100% of output signal).
Measuring Accuracy:                 ± 20% of final value (referred to calibrating gas)
Service Life:                                      > 60 months
Gas Exchange:                                 By diffusion
Warm-up Time:                              Approx. 1 hour
Ambient Temperature:              0…+50˚C
Response Time:                              Approx. 1 minute
Electrical Connection:                0.14 – 1.5mm², via terminals
Enclosure:                                           Plastic, material ABS, colour pure white (similar to RAL 9010), stainless steel enclosure optional
Dimensions:                                       85 x 85 x 27mm (Baldur 1) 100 x 100 x 25mm (stainless steel)
Installation:                                        Wall mounting or on an in-wall flush box, Ø55mm, base with 4 holes for mounting vertically or horizontally installed in-wall flush boxes for cable entry from the back, with a predetermined breaking point for on-wall cable entry from top / bottom in case of plain on-wall installation.
Protection Class:                              III (according to EN 60730)
Protection Type:                               IP 30 (according to EN 60529)
Standards:                                            CE conformity, electromagnetic compatibility according to EN 61 326, EMC Directive 2014 / 30 / EU, Low Voltage Directive 2014 / 35 / EU